Post by vmrod on Jan 30, 2009 13:55:55 GMT -3
A couple pointers for this part.
1. It might be plausible to simply buy Granada spindles, and cutoff the area where the upper ball joint connects. (proper tapered holes are already there!) You would then weld this chunk as required to those side plates.
2. If you will fab FA-SM-23. Here is a link (thanks Cal) for a drill bit. www1.mscdirect.com/CGI/NNSRIT?PMAKA=04356135 Note: If you browse the net, you might find a coupon. (I got a $26 discount for this!!)
1. It might be plausible to simply buy Granada spindles, and cutoff the area where the upper ball joint connects. (proper tapered holes are already there!) You would then weld this chunk as required to those side plates.
2. If you will fab FA-SM-23. Here is a link (thanks Cal) for a drill bit. www1.mscdirect.com/CGI/NNSRIT?PMAKA=04356135 Note: If you browse the net, you might find a coupon. (I got a $26 discount for this!!)
